Bharat Sanchar Nigam Limited

Switch 3560CX configuration template
for remote site AP connectivity

15th March 2017
Version 1.0
DCP – 0.2

................................. 8 .......................................................... 7 4...... Reference document .......... Configuration of switch for AP connectivity at remote location ........ 5 3............................................................................. 3 2..................................................................................................................................................................................................................... Lightweight AP CLI configuration ..Contents 1 About Catalyst 3560-CX switch ............

1 About Catalyst 3560-CX switch 3560-CX switch • 8 Gigabit Ethernet ports • 2 x 1 GE copper uplinks • 2 x 1 GE SFP uplinks • IP base (IP services with RTU license) PoE+ support with up to 240 W of PoE budget .

Product Overview • The Cisco Catalyst 3560-CX Compact Switches help optimize network deployments. These Gigabit Ethernet (GbE) and Multigigabit Ethernet (mGig) managed switches are ideal for high-speed data connectivity. wireless access points. and video endpoints. PCs. Wi-Fi backhaul. Cisco Catalyst compact switches enable IP connectivity for devices such as IP phones. surveillance cameras. and Power over Ethernet (PoE+) connectivity in places where space is at a premium. . With a single copper or fiber cable from the wiring closet.

Configuration of switch for AP connectivity at remote location Switch will be connected to upstream device with VLAN 4066. With VLAN 4066 configuration Switch#config t Switch(config)#VTP mode transperent Switch(config)#hostname <enter the hostname as per the standard> Switch(config)#vlan 4066 Switch(config)#interface vlan 4066 Switch(config-if)#ip address < management ip address of switch > <IP subnet mask> Switch(config)#ip default-gateway < IP address of default gateway-BNG > Uplink port configuration in PoE switch: Switch(config)#interface GigabitEthernet0/9 Switch(config)#switchport mode trunk Switch(config)# switchport trunk allowed vlan 4066 Switch(config)# no shut end Note: upstream switch uplink port also should be configured same as trunk port with allowed vlan 4066. 2. uplink will be connected with trunk configuration however respective ports that are used for AP connectivity will be configured with VLAN 4066 as access port and along with that management IP address will be configured on switch. . in this case.

Port configuration on which AP’s will be connected Switch(config)#interface <interface ID> Switch(config)# description <please put the description with AP name which will be connected to this port> Switch(config)#switchport mode access Switch(config)# switchport access vlan 4066 Switch(config)# no shut .

you can use these EXEC mode CLI commands: AP#capwap ap ip address <IP address> <subnet mask> AP#capwap ap ip default-gateway <IP-address> AP#capwap ap controller ip address <IP-address> AP#capwap ap hostname <name as per the standard> To verify the details in AP. Lightweight AP CLI configuration Below are the commands to statically configure the information necessary to join a controller via the console port and the AP’s CLI.3. In order to manually configure static information on a LAP using the AP CLI interface. please enter below commands: AP# show capwap client rcb AP# show capwap client config .

html AP registration to WLC: http://www. Reference document Please refer below link for more details: Installation guide: http://www.html . 4.com/c/en/us/td/docs/switches/lan/catalyst2960cx_3650cx/hardware/installation/guide/b_2960cx- 3560cx_hig.cisco.com/c/en/us/support/docs/wireless-mobility/wireless-lan-wlan/70333-lap-registration.pdf Datasheet of 3560 switch: http://www.cisco.com/c/en/us/products/switches/catalyst-3560-cx-series-switches/datasheet-listing.cisco.