You are on page 1of 1

Packet Tracer - Skills Integration Challenge

Topology
Note: You can use this document to record the random values (router names, addressing, etc.) that you will
receive when launching the Packet Tracer activity.

Addressing Table

Device Interface IP Address Subnet Mask

Class-A VLAN 1 128.107.20.10 255.255.255.0
Class-B VLAN 1 128.107.20.15 255.255.255.0
Student-1 NIC 128.107.20.25 255.255.255.0
Student-2 NIC 128.107.20.30 255.255.255.0

Objectives
• Configure hostnames and IP addresses on two Cisco Internetwork Operating System (IOS) switches
using the command-line interface (CLI).
• Use Cisco IOS commands to specify or limit access to the device configurations.
• Use IOS commands to save the running configuration.
• Configure two host devices with IP addresses.
• Verify connectivity between the two PC end devices.

Scenario
As a recently hired LAN technician, your network manager has asked you to demonstrate your ability to
configure a small LAN. Your tasks include configuring initial settings on two switches using the Cisco IOS and
configuring IP address parameters on host devices to provide end-to-end connectivity. You are to use two
switches and two hosts/PCs on a cabled and powered network.

Requirements
• Use a console connection to access each switch.
• Name Class-A and Class-B switches.
• Use the 8ubRu password for all lines.
• Use the c9Wre secret password.
• Encrypt all clear text passwords.
• Include the word warning in the message-of-the-day (MOTD) Banner.
• Configure addressing for all devices according to the Addressing Table.
• Save your configurations.
• Verify connectivity between all devices.
Note: Click Check Results to see your progress. Click Reset Activity to generate a new set of requirements.
If you click on this before you complete the activity, all configurations will be lost.

© 2013 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public. Page 1 of 1