300-135 Troubleshooting and Maintaining Cisco IP

Networks (TSHOOT) exam in just 24 HOURS!

100% REAL EXAM QUESTIONS ANSWERS

300-135 Troubleshooting and Maintaining
Cisco IP Networks (TSHOOT)
Buy Complete Questions Answers File from

http://www.exams4sure.com/Cisco/300-135-practice-examdumps.html
100% Exam Passing Guarantee & Money Back
Assurance

Sample Questions

Question No 1:
Exhibit:

A network administrator is troubleshooting an EIGRP connection between RouterA, IP
address 10.1.2.1, and RouterB, IP address 10.1.2.2. Given the debug output on RouterA,
which two statements are true? (Choose two.)
A.
B.
C.
D.
E.
F.

RouterA received a hello packet with mismatched autonomous system numbers.
RouterA received a hello packet with mismatched hello timers.
RouterA received a hello packet with mismatched authentication parameters.
RouterA received a hello packet with mismatched metric-calculation mechanisms.
RouterA will form an adjacency with RouterB.
RouterA will not form an adjacency with RouterB.

Answer: D, F
Question No 2:
When troubleshooting an EIGRP connectivity problem, you notice that two connected
EIGRP routers are not becoming EIGRP neighbors. A ping between the two routers was
successful. What is the next thing that should be checked?
A. Verify that the EIGRP hello and hold timers match exactly.
B. Verify that EIGRP broadcast packets are not being dropped between the two routers
with the show ip EIGRP peer command.
C. Verify that EIGRP broadcast packets are not being dropped between the two routers
with the show ip EIGRP traffic command.
D. Verify that EIGRP is enabled for the appropriate networks on the local and
neighboring router.

Answer: D

Question No 3:
Which IPsec mode will encrypt a GRE tunnel to provide multiprotocol support and
reduced overhead?
A.
B.
C.
D.

3DES
Multipoint GRE
Tunnel
Transport

Answer: D
Question No 4:
Which three features are benefits of using GRE tunnels in conjunction with IPsec for
building site-to-site VPNs? (Choose three.)
A.
B.
C.
D.

B.Supports multi-protocol (non-IP) traffic over the tunnel
Reduces IPsec headers overhead since tunnel mode is used
Simplifies the ACL used in the crypto map
Uses Virtual Tunnel Interface (VTI) to simplify the IPsec VPN configuration

Answer: A, B, D
Question No 5:
Which statement is true about an IPsec/GRE tunnel?
A. The GRE tunnel source and destination addresses are specified within the IPsec
transform set.
B. An IPsec/GRE tunnel must use IPsec tunnel mode.
C. GRE encapsulation occurs before the IPsec encryption process.
D. Crypto map ACL is not needed to match which traffic will be protected.

Answer: C

Question No 6:
Refer to the exhibit.

How would you confirm on R1 that load balancing is actually occurring on the defaultnetwork (0.0.0.0)?
A. Use ping and the show ip route command to confirm the timers for each default
network resets to 0.
B. Load balancing does not occur over default networks; the second route will only be
used for failover.
C. Use an extended ping along with repeated show ip route commands to confirm the
gateway of last resort address toggles back and forth.
D. Use the traceroute command to an address that is not explicitly in the routing table.

Answer: D
Question No 7:
The implementations group has been using the test bed to do a `proof-of-concept' that
requires both Client 1 and Client 2 to access the WEB Server at 209.65.200.241. After
several changes to the network addressing, routing scheme, DHCP services, NTP
services, and FHRP services, a trouble ticket has been operated indicating that Client 1
cannot ping the 209.65.200.241 address.
Use the supported commands to Isolated the cause of this fault and answer the
following questions. On which device is the fault condition located?

A.
B.
C.
D.
E.
F.
G.
H.

R1
R2
R3
R4
DSW1
DSW2
ASW1
ASW2

Answer: G
Question No 8:
The implementations group has been using the test bed to do a `proof-of-concept' that
requires both Client 1 and Client 2 to access the WEB Server at 209.65.200.241. After
several changes to the network addressing, routing scheme, DHCP services, NTP
services, layer 2 connectivity, FHRP services, and device security, a trouble ticket has
been opened indicating that Client 1 cannot ping the 209.65.200.241 address.
Use the supported commands to isolated the cause of this fault and answer the
following questions. The fault condition is related to which technology?
A.
B.
C.
D.
E.
F.

NTP
Switch-to-Switch Connectivity
Access Vlans
Port Security
VLAN ACL / Port ACL
Switch Virtual Interface

Answer: D
Question No 9:
The implementations group has been using the test bed to do a `proof-of-concept' that
requires both Client 1 and Client 2 to access the WEB Server at 209.65.200.241.
After several changes to the network addressing, routing scheme, DHCP services, NTP
services, and FHRP services, a trouble ticket has been opened indicating that Client 1
cannot ping the 209.65.200.241 address.
Use the supported commands to isolated the cause of this fault and answer the
following questions.
What is the solution to the fault condition?

A. In Configuration mode, using the interface port-channel 13 command, then
configure switchport trunk allowed vlan none followed by switchport trunk allowed
vlan 20,200 commands.
B. In Configuration mode, using the interface port-channel 13, port-channel 23, then
configure switchport trunk none allowed vlan none followed by switchport trunk
allowed vlan 10,200 commands.
C. In Configuration mode, using the interface port-channel 23 command, then
configure switchport trunk allowed vlan none followed by switchport trunk allowed
vlan 20,200 commands.
D. In Configuration mode, using the interface port-channel 23, port-channel, then
configure switchport trunk allowed vlan none followed by switchport trunk allowed
vlan 10,20,200 commands.

Answer: B
Buy Complete Questions Answers File from

100% Exam Passing Guarantee & Money Back
Assurance
 PDF Version + Test Engine Software Version
 90 Days Free Updates Service
 Valid for All Countries

http://www.exams4sure.com/Cisco/300-135practice-exam-dumps.html